![Crux Sightline PCM-3 Скачать руководство пользователя страница 5](http://html.mh-extra.com/html/crux/sightline-pcm-3/sightline-pcm-3_manual_2691600005.webp)
CODING THE VEHICLE
In order to activate the Rear-View Camera feature, the installer must CODE the car rst.
Step 5
- While listening to the FM Source, place dip switch number “2” to the “ON” position on the module.
The screen will power o and begin to reset.
DIP SWITCH DESCRIPTION
LOCATED ON THE CAN MODULE.
DIP 1 =
Video In-Motion Enable
DIP 2 =
Factory Rear-View Camera
DIP 3 =
Code Rear-View Cam w/ White Wire
DIP 4 =
Code Park Assist w/ White Wire
DIP 5 =
Not Used
DIP 6 =
Can-Bus Termination
TECH TIP:
IN THE CASE THAT THE VEHICLE IS MANUAL TRANSMISSION, THE INTERFACE WILL NOT PROVIDE YOU
THE REVERSE OUTPUT. YOU WILL NEED TO TAP THE CARS REVERSE LIGHT TO THE GREEN WIRE FROM
THE 8-PIN CONNECTOR ON THE MODULE.
Step 1. Remove the GREEN wire
(Pin 2) from the 8-Pin
connector.
Step 2. Connect the GREEN wire to
the REVERSE light from the
car. We recommend using a
DIODE when connecting.
Step 3. Make sure nothing is populating
Pin 2 on the 8-Pin connector.
After each change of the DIP switch settings,
we recommend powering down the module,
then restarting the vehicle.
LED INDICATORS
DATALINK LED:
Blinking = BUS Detected.
OFF = Power Down/ Sleep mode.
POWER LED:
ON = Power On
OFF = Power OFF
UP=ON
DOWN=OFF
8-PIN
(male plug)
GREEN (PIN 2)
/
REMOVE FROM 8-PIN
TO REVERSE LIGHT
CATHODE TOW ARDS LIGHT
DIODE
(NOT INCLUDED)
Rear-View Integration Interface for
PORSCHE Vehicles with PCM-3 or PCM-3.1 Systems
PCM-3
R
INTERFACING SOLUTIONS
Sightline
REAR-VIEW INTEGRATION
Crux Interfacing Solutions • 6860 Canby
Ave., Suite 1
16, Reseda, C
A 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www
.cruxinterfacing.com
5 of 10
rev.051718