Step 8
- Now you may proceed to installing the Rear-View Camera. Make sure to use the 8-Pin connector for REVERSE and GROUND
for the camera. (See Installation Overview)
Note:
The vehicle display o ers a Zoom + and Zoom - option, this interface does not
support this option.
DECODING THE VEHICLE REAR-VIEW CAMERA
In the case where you need to decode the aftermarket rear-view camera input, please do the following:
Step 9
- With the T-Harness and interface
module properly connected, turn the
ignition to the “ON” position.
Wait for the head unit to power on then
proceed to the following steps.
On the left side of the steering wheel:
1. Press and Hold both the “Hash Key”
and “End Call” buttons for 10 approx.
10 seconds. (See page 5 for HASH Key)
During the coding process, the Red
and Blue LED will begin
.
2. After the head unit has began to reset,
release both buttons. The Red and Blue
LED’s will glow solid to identify the
coding has been completed.
ON
1 2 3 4 5 6
40-PIN
(male plug)
40-PIN
(female plug)
8-PIN
(male plug)
GREEN/
REVERSE WIRE
WHITE /
ALTERNATIVE CODING
CAN
INTERFACE
CAMERA
(INCLUDED NOT INCLUDED)
YELLOW
/ VIDEO SIGNAL
CAMERA INPUT
TAP BLACK /
CAMERA GROUND
4 5 6
ON
1 2 3
DIP 1 = ON
2 = ON
3
4
5
DIP 6 = ON
OFF
VIDEO
IN-MOTION
DIP 1 = OFF
2 = ON
NO
CAN
INTERFACE
END CALL
Rear-View Integration Interface for
PORSCHE Vehicles with PCM-3 or PCM-3.1 Systems
PCM-3
R
INTERFACING SOLUTIONS
Sightline
REAR-VIEW INTEGRATION
Crux Interfacing Solutions • 6860 Canby
Ave., Suite 1
16, Reseda, C
A 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www
.cruxinterfacing.com
7 of 10
rev.051718
