Crutchfield 019 0021, Руководство по установке

Страница: 13 / 14

019 0021
Wire Splicing Guide
These methods can be used to make wiring connections if no receiver or speaker wiring adaptor is available.
Wire color information (if available) can be found on the next page.
13
Copyright 2018 Crutchfield Corporation
1-800-955-9094
TECHNICAL SUPPORT
- - - - - -
+ + + + + + + + + + + + + + + + + + +
+ + + +
+ + + + + + + + +
-
-
-
-
-
-
2. Twist wires from new
speaker to stripped
sections of factory wires
as shown making sure
polarity is correct.
- - - - - - - -
+ + + + + + + + + + + + + + + + + + + + + +
+ + +
+ + + + + + + + + +
-
-
-
-
-
-
Factory Wires Factory Wires
Strip Out 1/2” Strip Out 1/2”
New Wires New Wires
Positive Wires Positive Wires
Negative Wires Negative Wires
First First
Last Last
CRIMP METHOD SOLDER METHOD
2. Strip end of each
wire back 1/2”.
1. Cut factory wires behind
factory speaker harness.
3. Twist each positive pair of
wires together and insert
in crimp cap. Repeat
step for negative wires.
4. Squeeze middle of cap
for tight connection.
5. Connect new wires to
speaker with spade
connectors.
1. Carefully strip out a 1/2”
section on each factory
speaker wire behind the
factory speaker harness.
3. Heat wires first with
soldering iron, then
touch solder to
wires for solid
connections.
4. Wrap wiring connections
with electrical tape.
5. Connect new wires to
speaker with spade
connectors.
Factory harness is removed. Save
harness if it is to be reconnected in
the future by this method. New speaker wires are spliced into
factory wires behind harness.
Factory Wire Factory Wire
New Speaker Wire New Speaker Wire