10
Auger System
Hanger Bearing
The hanger bearing in your cart is a 2½" bronze bearing and should last many years. Grease
periodically.
Item Part No.
Description
1
967513
Hanger Bearing Holder
2
403527
Bronze Bushing
2 33/64" x 3 1/4" x 1 3/4"
3
227520
Back Up Plate
4
01147800 HHCS ½" x 1½"
5
330159
Flat Washer ½"
6
330134
Hex Nut ½"
Drive Collar
The drive collar or the drive pin may become worn or damaged in time and may need to be
replaced. The drive pin can be purchased separately and replaced by welding it in place. Care
should be taken to align it as it was originally. The pin should be welded with low hydrogen welding
rods.
If the augers seem to bind when locking together in the upright position, then check the inside of
the top drive bushing. Sometimes it may become burred, as may the pilot shaft. Smoothing the
burred surfaces should correct the problem. The drive collar can be turned over and the unworn
side used. It is attached to the pilot shaft using two keys and set screws.
DO NOT fold the augers while they are turning. This will cause damage to the drive collar.
Item Part No.
Description
1
607457
Drive Collar 2½"
2
311670
Key ½" x 1 3/4"
3
337998
Screw 3/8" x 1" Socket Head
Clean Out Door
Clean out door is for grain pit dumping. It also allows easy access to auger drive plate and bottom
of auger. Crank in front of cart allows opening and closing of door.
Always have door closed when using in the field.
CAUTION:
Keep hands out when
tractor is running.
Item Part No.
Description
640094
Clean Out Door
1
640078
Door Frame
2
640086
Door Cover
