6
Safety Decals
#608018
#608026
Operating Instructions
NEVER allow anyone to ride or play on the grain cart.
NEVER enter the grain cart with the PTO or hydraulic motor running or when it contains grain.
Make sure all guards are in place.
Daily grease auger hinge pin, u-joints, and over running coupler.
The grain flow control door (inside slide door) and the clean out door should both be closed
when loading the cart or transporting the cart when filled with grain.
Extending the auger- Use care when folding and unfolding the auger. Make sure no one is
close to the auger. DO NOT extend auger when close to any electrical lines. DO NOT try to
extend or fold the auger while it is running.
If equipped with a PTO drive, slowly engage the PTO at a low RPM, and then slowly increase
to desired tractor RPM. Do not exceed 1000 RPM on PTO.
If equipped with a hydraulic drive, set tractor RPM to 1700 RPM. Snap open hydraulic valve
in tractor. DO NOT slowly open valve. After auger is turning, increase tractor to approximately
2200 RPM.
Slowly open grain flow door after auger is up to speed. Door fully open allows maximum flow.
Use “Clean Out” setting to empty all the grain from the cart.
Use the door to slow grain flow if necessary. DO NOT run auger at slow speed. DO NOT start
auger with the grain flow door open.
Unload the cart.
DO NOT disengage the auger while unloading without first closing the grain flow door.
It is advisable to return the tractor to idle before disengaging the auger.
If you must return to the field or otherwise halt the unloading with a partial load of grain, then
close the grain flow door and let the auger finish emptying the grain left in the auger tubing.
DO NOT return with a partial load and the grain flow door open.
It is recommended to transport the grain cart in the field with auger in the folded position, then
extend when unloading the cart.
