Crunch GTX 3000 D, Руководство пользователя

Страница: 21 / 28

G T X 3 0 0 0 D
2 1
INTERCONNECTION MASTER
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.
• Connect the bass remote wire only on the REMOTE port of the MASTER amp.
INTERCONNECTION SLAVE
• Connect the RCA jacks SLAVE IN/OUT of the MASTER amp with the RCA jacks SLAVE IN/OUT of the SLAVE amp with appropriate
high-value RCA cables.
• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.
Use therefore cable with a minimum profile section of 0,5 mm 2 .
• Connect the PROTECT BRIDGE port of the MASTER amp with the PROTECT BRIDGE port of the SLAVE amp with the enclosed
PROTECT BRIDGE wire.
INTERCONNECTION SUBWOOFER
• Attend page 22.
SETTINGS MASTER
• The MODE switch should be in MASTER position.
Attend therefor the information of LOW PASS, SUB SONIC, PHASE, LEVEL, SUB BOOST, FREQ RANGE, Q-CONTROL and BASS
REMOTE on page 20.
SETTINGS SLAVE
• The MODE switch must be in SLAVE position.
In the SLAVE mode all controllers of the SLAVE amp are without function.
Only the already modified audiosignal of the MASTER amp will be amplified.
INTERCONNECTION EXAMPLE Master/Slave Mode
1. Connect Stereo RCA output (L/R
or SUB OUT) of the headunit with the
LINE INPUT CH1/2 of the MASTER amp
Connect the bass remote
controller and the remote terminal
at the amplifier (MASTER)
with the enclosed cable.
Switch setting = MASTER
SLAVE MASTER
Switch setting = SLAVE
Remote wire REM Remote wire REM
Protect Bridge wire
Remote wire REM
2. Connect Stereo RCA output (SLAVE IN/OUT)
of the MASTER amp with the SLAVE IN/OUT
of the SLAVE amp
1.
2.