–
Perc Paradise Mod
: this is a “hack” that causes the percussion to never decay.
What's special in this is that if you activate the scanner vibrato effect, you'll
notice that the vibrato is applied to the rest of the drawbars but not to the
percussion tone.
–
Other settings
: here you can adjust the depth of the vibrato circuit and the mix
amount that affects the chorus settings, plus some parameters related to the
generation of the KeyClick noise.
–
Preamp Bass / Treble
: adjust the frequency response of the organ's built-in
preamp circuitry.
Parameters for the Rotary Speaker are:
–
Horn slow / fast
: adjust the speed offset of the horn for when the speed is on
slow or on fast.
–
Bass slow / fast
: same as above but for the bass rotor.
–
Horn up / down
: adjust the acceleration and deceleration times of the horn for
the transitions between the slow and fast speeds. When the brake is engaged,
the power is taken off from the motor so the horn slows down until stopping
only driven by the centrifugal force, so the time between fast and stop may be
longer than from fast to slow.
–
Bass up / down
: same as above but for the bass rotor.
–
Ambience
: a real amplifier stays in a real environment causing the
microphones to capture the sound reflections as well as the direct sound
coming from the speakers. This parameter adjusts the amount of
environmental reflections.
–
Cabinet
: adjusts the amount of resonances caused by the wooden cabinet.
–
Mic Angle
: adjusts the angle between the two microphones at the horn,
ranging from 0 (both microphones in the same spot) to 180 degrees
(microphones at the opposite sides of the cabinets). This simulation considers
only three microphones, two for the horn and one for the bass rotor.
–
Horn EQ
: not all vintage rotary speakers have the same quality for what
concerns the sound coming from the horn, some are brighter, some are duller
or maybe just well balanced. This parameter lets you adjust the treble response
of the horn sound.
CRUMAR MOJO CLASSIC & SUITCASE USER'S MANUAL - Page 15/20