CRT SuperStar, Руководство пользователя

Страница: 6 / 11

REAR PANEL
1. ANTENNA :
This jack accepts 50 ohms coaxial cable with a PL-259 type plug.
2. DC POWER :
This accepts 13.8V DC power cable with built-in fuse. The power
cord provided with the radio has a black and red wire. The black goes to negative
and red goes to positive.
3. EXT. SP :
This jack accepts 4 to 8 ohms, 5 watts external speaker. When the
external speaker is connected to this jack, the built-in speaker will be disabled.
4. CW. KEY :
This jack is for Morse Code operation. To operate, connect a CW Key
to this jack and place the Mode Control in the CW position.
PROCEDURE TO RECEIVE AND TRANSMIT
A. MICROPHONE
The receiver and transmitter are controlled by the push-to-talk switch on the
microphone. Press the switch and the transmitter is activated, release switch to receive.
When transmitting, hold the microphone two inches from the mouth and speak clearly
in a normal voice. This transceiver comes complete with a low impedance dynamic
microphone.
B. PROCEDURE TO RECEIVE
1. Be sure that power source, microphone and antenna are connected to the proper
connectors before going to the next step.
2.
Turn
VOL
knob clockwise to apply power to the radio.
3.
Set the
VOL
for a comfortable listening level.
4.
Set the
MODE
switch to the desired mode.
5.
Listen to the background noise from the speaker. Turn the
SQ
knob slowly
clockwise until the noise just disappears. The
SQ
is now properly adjusted. The
receiver will remain quiet until a signal is actually received. Do not advance the
control too far or some of weaker signals will not be heard.
6.
Set the
CHANNEL
selector switch to the desired channel.
7.
Set the
RF GAIN
control fully clockwise for maximum RF gain.
8.
Adjust the
FINE/COARSE
control to clarify the SSB/CW signals or to optimize
AM/FM signals.
C. PROCEDURE TO TANSMIT
1. Select the desired channel of transmission
2.
Set the
MIC GAIN
control fully clockwise.
3.
If the channel is clear, depress the push-to-talk switch on the microphone and speak
in a normal voice.
11 10
- DC 13,8V +