CRT SuperStar, Руководство пользователя

Страница: 5 / 11

5. E-TONE CONTROL :
This control is used to control the echo effects.
6. RF POWER CONTROL :
This control enables adjustment of RF power output
continuously up to the rated output power.
7. BAND SELECTOR :
This band selector allow the user to select the desired band.
8. MODE CONTROL :
This control allows you to select one of the following
operating modes : CW/FM/AM/USB/LSB.
9. FINE/COARSE CONTROL :
Allows variation of the receive operating
frequency above or below the assigned frequency. Although this control is intended
primarily to tune in SSB/CW signals, it may be used to optimize AM/FM signals as
described in the Operating Procedure paragraphs. Coarse operates both TX/RX but
Fine only in RX.
10. CHANNEL SELECTOR :
This control is used to select a desired transmit and
receive channel.
11. MICROPHONE JACK :
Used to connect microphone for voice source.
12. FRONT PANEL METER :
The Front Panel Meter allows the user to monitor
signal strength, RF output power and SWR level.
13. TX/RX LED :
The red LED indicates the unit is in the transmit mode. The green
LED indicates the unit is in the receive mode.
14. FREQUENCY COUNTER :
This frequency counter indicates the selected
channel frequency digitally.
15. TALKBACK SWITCH :
This switch is used to monitor the sound feedback
effects.
16. HI/LOW SWITCH :
This switch select HI or LOW band of operation.
17. NB/ANL/OFF SWITCH :
When the switch is place in the NB/ANL position, the
RF Noise Blanker (NB) and the Automatic Noise Limiter (ANL) in the audio
circuits are activated. The Noise Blanker is very effective in eliminating repetitive
impulse noise such as ignition interference.
18. S-RF/SWR/ SWITCH :
In the S-RF position, the meter swings proportionally to
the strength of the received signal. When transmitting, the meter indicates relative
RF output power. When in the SWR position, the standing wave ratio is measured.
19. ROGER BEEP :
When this switch is placed in the ROGER BEEP position, the
radio automatically transmits an audio tone at the end of your transmission. This
indicates the end of your transmission so that people who are having trouble
hearing you will know that you are done speaking. As a courtesy to others, use the
Roger Beep only when necessary.
20. +10KHz SWITCH :
In the +10KHz position, the transmit and receive frequency is
shifted 10 KHz up.
21. CHANNEL DISPLAY :
The channel display indicates the current selected
channel.
9 8
1 to 25 Watts (AM : 1W to 10W - SSB : 10W to 25W)