Place the cabinet in the desired position on the
wall and mark the position of the top mounting
hole. Note that single door cabinets can be
positioned with either a left or right opening door.
Simply turn the cabinet upside down to change
the door opening direction.
Fasten the top bracket to the wall ensuring the
O-ring is correctly seated at the back of the
bracket. Do not overtighten!
(This image shows the solid wall installation.)
Hang the cabinet onto the top wall bracket, (see
image 1) and secure in place by screwing the
locking cap and spacer onto the top bracket, (see
image 2).
Place the cover onto the locking cap, (see image 3).
Image 1
Image 2
Image 3
1.
2.
3.
4.
Page 3
IMPORTANT NOTE: THE TOP BRACKET HAS A SMALLER DIAMETER OUTER FLANGE TO THE BOTTOM BRACKET.
For solid walls drill a
5
/
16
” (8mm) diameter hole in the marked
postion and insert a wall plug flush to the surface of the
wall. If fitting to a tiled surface, the wall plug should be
inserted below the surface of the wall to avoid cracking the
tiles.
For cavity walls drill an
7
/
16
” (11mm) diameter hole and
assemble the top bracket and metal washer onto the toggle
bolt as shown above. Ensure the 11mm diameter toggle
bolt insert is pushed into the hole in the plaster board wall
for maximum strength.
Metal Washer
7/16” (11mm)
diameter toggle
bolt wall insert
Top Bracket
(Small Diameter)
IMPORTANT!
If the wall plugs are not inserted flush with the wall
surface, the O-ring will not contact the wall correctly.
This will prevent the bracket from functioning properly.
1
2
3
CAB 140 R07
UK: Croydex, Central Way, Andover,
Hampshire, SP10 5AW, UK
EU: MIL, Unit 8 Purcellsinch Ind Est, Dublin
Road, Kilkenny, R95 HP71, Ireland
+44 (0) 1264 365881
+44 (0) 1264 356437
www.croydex.com
5
/
16
” or
7
/
16
”
(8mm or 11mm)
drill bit.
5
4
6
7
8
