CAB 128 R02
Fixing Instructions
1. Hold the cabinet against the wall in its desired location. Check
that the cabinet is straight and level using a spirit level. Open the
doors and mark the wall through the holes in the back of the
cabinet with a pencil (see Fig 2).
2. Using a 6.5mm masonry drill, drill the holes in the marked
positions to a depth of 35mm. If drilling through tiles, please pre-
drill using a ceramic drill bit. Insert the wall plugs to the surface of
the wall. If fitting to a tiled surface, the wall plugs should be
inserted below the surface of the tile to avoid cracking.
3. Hold the cabinet against the wall and align the holes in the back of the cabinet with the wall
plugs - make sure the pre-drilled door knob locating holes are on the lower part of the doors.
Insert the mounting screws through the holes in the back of the cabinet and screw into the
wall plugs.
4. To fit the knobs to cabinet place a plastic washer over the
end of each door knob and insert the end of each door
knob into the holes on the mirrored side of the doors.
Secure the door knobs in place using the door knob
screws – DO NOT over-tighten the screws (see Fig 3).
Product Care Advice
To retain the best quality finish, clean product regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as these will damage the product.
Please retain this leaflet for future reference.
Mounting holes
Fig 2
Croydex, Central Way, Andover, Hampshire, SP10 5AW, UK
+44 (0) 1264 365881
www.crodyex.com
