Crown GLT-20, Руководство по установке и эксплуатации

Страница: 10 / 32

INSTALLATION & OPERATION MANUAL 10070 REV 0 (04/21) PAGE
10
OF 32
G as F ired S team T ilting K ettles O
PERATION
D aily O peration
Daily operation should consist of turning on the power switch and setting thermostat for the desired temperature.
It is recommended the kettle be preheated prior to use. Milk or egg based products should be placed in the kettle before
heating however, to prevent sticking. The kettle is preheated when the cooking light goes off the first time.
At the end of the day, or if the kettle will not be used for some time, shut the unit down by turning the power switch to “OFF”.
Clean as required or on a daily basis. See “CLEANING INSTRUCTIONS” section.
E nd U se T ips
For easier cleaning add cold water to the kettle immediately after removing contents.
When preparing foods containing vinegar or tomatoes, or those which have a high salt content, clean the kettle
immediately after using to prevent pitting.
Do not use salt to clean the kettle. This will scratch the surface.
If using salt water to cook shellfish, be sure to rinse and wash the kettle thoroughly after use.
Bring milk and egg products slowly up to temperature in a cold kettle to prevent product from adhering to the sides. When
preparing milk-based products do not preheat the kettle.
When planning actual cooking capacity, allow room at top for stirring without spilling.
When preparing puddings from a mix, place the powder in a cold kettle, add a small amount of liquid, and stir to form a
thin paste. Turn on the kettle and add the remainder of the liquid.
Continue as per recipe instructions.
When browning meat, bring the kettle up to temperature before adding. This will seal the juices in the meat.
G as S aving T ips
Use these reminders to help develop energy-saving procedures and habits. Using less natural or propane gas saves
energy as well as money.
1. Turn off when not in use.
2. Limit preheat times.
3. Use lid when possible.
4. Maintain equipment.