Crown CT15232, Оригинальное руководство пользователя

Страница: 20 / 132

20
English
• Press and hold the spindle lock 7 , tighten the bolt 26
by means of the wrench 15 � Then release the spindle
lock 7 �
• Make sure that cutting disc 9 does not touch any
elements of power tool and can rotate freely�
• Loosen the top screw 16 and move sliding guard
cover 10 in original location�
Initial operation of the power tools
Always use the correct supply voltage: the power
supply voltage must match the information quoted on
the power tool identification plate.
Switching the power tool on / off
Switching on:
In order to switch on the power tool, push lock-off
button 4 and while holding it in position, push on / off
switch button 5 �
Switching off:
In order to switch off the power tool, release on / off
switch 5 �
Recommendations on the power tool
operation
•
Place the power tool on the worktable� It's
recommended to fix power tool with cramps.
• If required, adjust the clamping device for cutting
a workpiece with required width and set the needed
cutting angle (the order of operations is described
above)�
• Lift the tiltable lever 13 and move the lead screw 12
until its rotary stop
11
touches the workpiece (see
fig. 8).
• Lower the tiltable lever 13 and turn the clamping
handle 14 to fix the workpiece (see fig. 8). Avoid
misalignment or skew of the workpiece�
• Turn on the power tool, allow cutting disc 9 to reach
the full rotation speed�
• Smoothly pull the body down and make the cut�
• Do not overload the power tool (especially when
cutting metal profiles, panel constructions, etc.) as it
will overload the motor and may damage the cutting
disc� There must be enough time for the power tool to
carry out the operation�
• Turn off the power tool and wait until cutting disc 9
stops completely�
• Lift the power tool body up smoothly�
• To remove the workpiece, lift the tiltable lever 13
and move the lead screw 12 back�
Power tool maintenance / preventive
measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean� During
the long treatment of metal, current-conducting dust
can be accumulated inside the power tool� Regularly
flush the power tool with compressed air thought the
ventilation slots 1 �
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com �
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging�
Environmental protection
Recycle raw materials instead of
disposing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper
manufactured without chlorine�
The manufacturer reserves the possibility to introduce changes.