CROWN VERITY PS-001, Руководство пользователя

Страница: 13 / 15

WHAT TO LOOK FOR
Propane tank is empty. Incorrect lighting procedures. Is
the cylinder valve turned on? Regulator assembly not
fully tightened to cylinder valve? Large plastic nut on
cylinder connector may be cracked or has been
overheated, may be wobbling and is not making a gas
tight seal inside cylinder valve. Remedy: Replace
regulator and hose assembly.
Control valve left open before
opening cylinder valve or leak in system causing flow
control device to activate. -Follow proper lighting
sequence or correct leak in system. Inspect burner for
obstructions
Slowly and gradually increase the gas supply from the
control regulator. The cylinder pressure has dropped
below operating pressure due to freeze-up. Long
periods of full- open operation will cause this. Remedy:
exchange L.P cylinder with a full one
techniques page 11.
WHAT HAPPENS
1) Burners will not light
2) Burner is not hot enough
3) Pro Steamer goes out
11
TROUBLESHOOTING GUIDE