Crown Royal Stoves RS7300MP, Инструкция по установке, эксплуатации и обслуживанию, Страница: 9 / 58

• All installation and operations must follow federal, provincial, state, and local codes for wire plumbing, and installing chimney.
• All work must be performed by qualified personnel only.
• Read and understand all precautions before operating the furnace.
• Furnace not to be used as a standalone unit. It is recommended that a backup system be in place.
• Retain this manual as long as you own your Crown Royal Stove. Carefully read and follow these directions. Regularly read over
this manual to keep you informed.
WARNINGS!!
• All installations and operations of your furnace must follow
STATE, PROVINCIAL and LOCAL LAWS pertaining to
operations, wiring, plumbing, and building codes. The
installation must be performed by a qualified installer.
• Only burn coal in this unit. (Check with provincial, state, and
local regulations that obtain to banned fuels in designated
locations)
• Do not install this unit on a combustible surface.
• All models operate at atmospheric pressure. DO NOT
obstruct, block or plug the overflow vent tube in any way,
which is located on top of the furnace.
• You must open the chimney flue before opening the furnace
door.
• This unit cannot be hooked to a chimney already serving
another appliance. When installing a chimney that is higher
than twelve feet, guide lines must be used.
• This unit must never be pressurized.
• Do not use an automatic stoker with this unit.
• Risk of Fire: Do not operate with fuel loading and/or ash
removal doors open. Do not store fuel or other combustible
materials within marked installation clearances. Inspect and
clean flues and chimney regularly.
CAUTIONS!!!
• Hot Surfaces: Keep children away. Do not touch during
operation.
• Do not start or operate furnace without checking heating fluid.
• Check for buried cables and utility lines before digging trench.
• For safety and proper temperature control, keep fuel door
closed tightly during operation.
• Do not fire up boiler until filled with water.
• Do not to start the unit during a prolonged power failure.
• Load fuel carefully to avoid injury to hands, fingers and other
body parts that may come in contact with the unit’s loading
door opening.
• Cleaning of the heat exchanger, flue pipe, chimney and draft
inducer if used, is especially important at the end of the
heating season to minimize corrosion during the summer
months caused by accumulated ash.
• When installing the heat exchanger, be sure none of the
existing system safety controls are disabled.
• When installing heat exchangers do not tamper with existing
controls. Wiring to existing blower can be done with a line
voltage or low voltage thermostat.
DANGER!!! Do not start fire with chemicals, volatile fluids, rubber, plastics or garbage. Only competent
persons with a sound understanding of this heating method should operate this furnace. Improper firing
could result in personal injury and/or damage to unit, and void warranty. Do not burn garbage,
gasoline, drain oil, naphtha, engine oil, railroad ties, particle board, leaves, cardboard, or any other
flammable liquids.
SAFETY INSTRUCTIONS & PRECAUTIONS
9