Crown Royal Stoves RS7300MP, Инструкция по установке, эксплуатации и обслуживанию, Страница: 29 / 58

If the furnace fails to heat up:
•
Check fire.
•
Check fan for operation.
•
Check that solenoid damper is open to allow air velocity.
•
Check water level of furnace.
•
Check for creosote blockage at chimney and bypass trough.
•
Check temperature setting.
•
Check for power at furnace.
If furnace water is hot, but buildings do not have heat:
•
Check pumps and check for closed valves.
•
Check filter or Y-Strainer for flow blockage.
•
Check for air in system at exchanger by bleeding off.
If furnace boils:
•
Check that door is closing properly and that door gasket is completely sealed.
•
Check that the ash pan door is properly closed and the gasket is completely sealed.
•
Check that the solenoid damper plate is opening and closing without hang-ups.
•
Check that the flexible air duct is connected to the blower and the bottom elbow of the furnace.
•
Check that the temperature settings are correct and water levels.
If furnace has shut down:
•
Check to ensure that the unit has power (does the outside light work).
•
Check the water temperature (furnace has a high temperature cut-out of 190 degrees F.).
•
If all the checks have not corrected the problem have a qualified technician check the control panel.
Blower will not come on:
•
Check to see if the high limit switches may be shut off because of water temperature is higher than aqua stat setting.
•
Wait and allow water to cool down. Reset snap disc.
TROUBLESHOOTING
29