Crown Boiler FSZ080, Руководство по установке

Страница: 8 / 52

6
IV Field assembly
This boiler is shipped in two pieces:
a) The crated boiler itself
b) The burner carton consisting of the following items:
• Oil Burner assembly
• Barometric Draft Regulator (if supplied)
• Safety valve
• Drain valve
• Pipe fittings
WARNING
Installation of burners on the FSZ other than those provided by Crown, and marked for use with this
boiler, may result in unreliable operation, property damage, personal injury, or loss of life.
It is recommended that the boiler be moved to its final location before the items in the burner carton are installed. To complete
field assembly:
1) Make sure that the burner carton supplied is the correct one for the boiler. The crate tag on the boiler lists the Crown part
numbers for the Beckett and Riello burner cartons that may be used with it.
2) Remove the burner mounting bolts and washers from the front door. Make sure that the burner gasket is in place and undam -
aged and mount the burner to the door as shown in Figure 4.0.
3) Plug the burner cord into the receptacle on the lower right front corner of the boiler.
4) The FSZ100 uses a pair of second pass baffles which are included in the burner carton and which must be installed in the
field. Install these as shown in Figure 4.0. All baffles are factory installed on other models.
5) Install the barometric draft regulator, and other piping/trim, as described in the Venting and Piping sections of this manual.
FIGurE 4.0: BOIlEr FIElD aSSEMBlY