INSTALLATION INSTRUCTIONS
S W A N Q U A D
PIR MOTION DETECTOR With PET IMMUNITY up to 25 kg
SETTING UP THE DETECTOR
PET IMMUNITYJUMPER SETTING
This jumper is used for setting the PET Immune
function - up to 15kg or 25kg, depending on the pet
size.
PULSE WIDTH JUMPER SETTING
This jumper is used for setting the PULSE count
function in order to provide PIR sensitivity control
according to the environment.
LED ENABLE JUMPER SETTING
This jumper is used for setting - LED Enable / Disable.
Note: The LED Switch does not affect the operation of
the relay.
When an intrusion is detected, the LED will activate
and the alarm relay will switch into alarm condition for
2 sec.
PIR SENSITIVITY ADJUSTMENT
Use the Potentiometer marked “SENS” to adjust the
detection sensitivity between 15% and 100%,
according to walk test in the protected area.
(Factory set to 57%)
Rotate the potentiometer clockwise to increase range,
counter-clockwise to decrease range.
Fig.5
BRACKET INSTALLATION OPTION
Ceiling bracket base Wall bracket base
Fig. 6
TECHNICAL SPECIFICATION
MODEL
SWAN QUAD
Detection Method
Quad (Four element) PIR
Power Input
8.2 to 16 VDC
Current Draw
Standby: 8mA (
±
5%)
Active: 10mA (
±
5%)
Temperature
Compensation
YES
Pulse Width
Adjustable
Alarm Period
2 sec (
±
0.5sec)
Alarm Output
N.C 28VDC 0.1 A with
27Ohm series protection
resistor
Tamper Switch
N.C 28VDC 0.1A with
10 Ohm series protection
resistor - open when
cover
is removed
Warm Up Period
60sec (
±
5sec)
LED Indicator
LED is ON during alarm
Operating Temperature
-20
°
C to +60
°
C
RFI Protection
30V/m 10 - 1000MHz
EMI Protection 50,000V of electrical
interference from lightning
or power through
Dimensions
92mm x 59mm x 37mm
Weight
40gr
CROW ELECTRONIC ENGINEERING LTD. ("Crow") - WARRANTY POLICY CERTIFICATE
This Warranty Certificate is given in favor of the purchaser (hereunder the "Purchaser") purchasing the products directly from Crow or from its authorized distributor.
Crow warrants these products to be free from defects in materials and workmanship under normal use and service for a period of 24 months from the last day of the week and
year whose numbers are printed on the printed circuit board inside these products (hereunder the "Warranty Period").
Subject to the provisions of this Warranty Certificate, during the Warranty Period, Crow undertakes, at its sole discretion and subject to Crow's procedures, as such procedures
are form time to time, to repair or replace, free of charge for materials and/or labor, products proved to be defective in materials or workmanship under normal use and service.
Repaired products shall be warranted for the remainder of the original Warranty Period.
All transportation costs and in-transit risk of loss or damage related, directly or indirectly, to products returned to Crow for repair or replacement shall be borne solely by the
Purchaser.
Crow's warranty under this Warranty Certificate does not cover products that is defective (or shall become defective) due to: (a) alteration of the products (or any part thereof)
by anyone other than Crow; (b) accident, abuse, negligence, or improper maintenance; (c) failure caused by a product which Crow did not provide; (d) failure caused by
software or hardware which Crow did not provide; (e) use or storage other than in accordance with Crow’s specified operating and storage instructions.
There are no warranties, expressed or implied, of merchantability or fitness of the products for a particular purpose or otherwise, which extend beyond the description on the
face hereof.
This limited Warranty Certificate is the Purchaser's sole and exclusive remedy against Crow and Crow's sole and exclusive liability toward the Purchaser in connection with the
products, including without limitation - for defects or malfunctions of the products. This Warranty Certificate replaces all other warranties and liabilities, whether oral, written,
(non-mandatory) statutory, contractual, in tort or otherwise.
In no case shall Crow be liable to anyone for any consequential or incidental damages (inclusive of loss of profit, and whether occasioned by negligence of the Crow or any
third party on its behalf) for breach of this or any other warranty, expressed or implied, or upon any other basis of liability whatsoever. Crow does not represent that these
products can not be compromised or circumvented; that these products will prevent any person injury or property loss or damage by burglary, robbery, fire or otherwise; or that
these products will in all cases provide adequate warning or protection.
Purchaser understands that a properly installed and maintained product may in some cases reduce the risk of burglary, fire, robbery or other events occurring without providing
an alarm, but it is not insurance or a guarantee that such will not occur or that there will be no personal injury or property loss or damage as a result.
Consequently, Crow shall have no liability for any personal injury; property damage or any other loss based on claim that these products failed to give any warning.
If Crow is held liable, whether directly or indirectly, for any loss or damage with regards to these products, regardless of cause or origin, Crow’s maximum liability shall not in
any case exceed the purchase price of these products, which shall be the complete and exclusive remedy against Crow.
P/N 7101570 REV. D Y.S - A.Y.
CROW ELECTRONIC ENGINEERING LTD.
12 Kineret St.
Airport City, 70100 Israel
Tel. +972 3 9726000
Fax. +972 3 9726001
[email protected]
[email protected]
www.thecrowgroup.com
CROW LATIN AMERICA USA INC.
7200 NW 19 st.
Suite 307
Miami FI 33126, USA
Tel. +305 513 4001
Fax. +305 513 4005
[email protected]
www.crowlatinamerica.com
ARROWHEAD ALARM PRODUCTS
344B, Rosedale Road
Park Farm Industrial Estate
Albany, Auckland
New Zealand
Tel. +64 9 414 0085
Fax. +64 9 414 0088
www.aap.co.nz
These instructions supersede all previous issues in circulation prior to December
2011.
7101570_D.doc
- 2 -
Immune to pet
weighting up to 15 kg
Immune to pet
weighting up to 25 kg
Very stable environment
Jumper #1 = ON
Without PET
Moderate nuisance situation
Jumper #2 = ON
PET up to 15 kg
Relatively high chance of false
alarms
Jumper #3 = ON
PET up to 25 kg
ON -
LED ENABLE. The LED will
activate when the detector is in
alarm condition.
OFF -
LED DISABLE, The LED is
disabled.
N345
