4
Maximum height of grass on
the ground = 0.3 m
Maximum depth of snow on the
ground = 0.5 m
Maximum lenght of protection zone = 60 m
Maximum width of protection zone = 8m
Maximum hight of protection zone = 3m
Instalation
height =
1 ~ 1.5 m
Dead Zone
1.5~2 m
Fig.1. Installation and Protection zone
Mounting the detector
Installation on Pole
Use metal or cement poles with a diameter of 90 ~ 100 mm as the support. It is
allowed to install two units on a single support; the two units must be identical (Two
transmitters or two receivers).
Installation height of R and T units should be in a way that the bottom surface of the
plastic housing will be 0.9 ~ 1m above the top of surface (ground and grass).
For pole installation use the two bands connected to the bracket and ensure reliable
fastening of the bands. The unused part of bands may be cut off.
Connect the plastic housing to the bracket using the nuts with the spherical support.
Top installation.
The CSB-60 can be also installed on top of fence or wall.
Installation height of R and T units should be in a way that the bottom surface of the
plastic housing will be 0.3m above top of fence or wall.
The support should be mechanically connected to the fence to ensure reliability.
Cross installation.
In order to avoid “dead zones” under aerials, and to increase the protected area, it is
possible to install multiple CSB-60 systems connected together with overlapping.
Overlap configurations are performed with the units located at the angles of
protected area. The minimum overlap for sufficient coverage must be at least 1.5 ~
2 m, (depending on the sensitivity set and installation height). It is recommended to
