CROSSRUNNER 50 ATV
ReAssembly Guide
12.
Install left engine side panel with the 3 screws and threaded
clips provided.
Step12-Fig1-Side panel attachment
13.
Caution! Battery acid is very caustic. Gloves and protective
clothing should be worn at all times when working with battery acid.
Any contact with skin or clothing should be flushed with water
immediately. Place battery on rubber or wood surface and carefully fill
battery according to instructions provided with the battery. When the
battery is full, install the cap and flush with water any acid that may be
on or around battery and then test for proper voltage. If the battery
meets the voltage specs called for in the battery instructions when
tested, install in ATV. The RED cables are positive (+) and the GREEN
cables are negative (-). Connect and tighten all battery cable
connections and see that the cables or any wiring cannot be pinched
when the battery cover is bolted into place. The battery has a dry
charge and should meet the 12.5-volt spec when filled with electrolyte.
If it does not meet the spec, charge according to the information
packaged with the battery and retest.
12
