User Manual and Reference Handbook for the CC Pilot™ XL
The power supply cable assembly’s wires, which are delivered by CrossControl, are
colour marked according to the table below.
Pin Signal
Colour marking
1 Not
Connected
-
2 ON/OFF
(+28
VDC)
Yellow
3
Battery (+28 VDC)
Pink
4
Preheating (+6 – +32 VDC) Green
5
ON/OFF (+28 VDC)
White
6 GND
Blue
7
Battery (+28 VDC)
Grey
8 GND
Brown
Heating via Preheating
To prepare for a fast start up of the CC Pilot™ XL in low temperatures preheating can be
used.
Preheating is initiated by a signal, from an external device, e.g., timer or motor heater, into
pin 4 on the power supply contact on CC Pilot™. When the signal is high the temperature is
continuously checked. If the temperature is below the defined setting the heater element is
activated, by default
+5 °C
. To save battery power, the LED indication and display is not
activated during preheat function.
Time before the unit starts up at different temperatures using the default settings.
External factors may affect the values; use them as a rule of thumb.
-40
˚
C -30
˚
C -20
˚
C -10
˚
C
Compact Flash 3 min
<1 min 0
0
HDD
20 min 15 min 10 min 5 min
Note that preheating requires power from the vehicle’s battery. This can result in the
vehicle not starting, after prolonged preheating of the PC and display, due to a flat
battery.
21
