Cross Technologies 2016-05A, Инструкция по эксплуатации

Страница: 8 / 16

2.2 Rear Panel Input/Output Signals - Figure 2.2 shows the input and output connectors on the rear panel.
AC1 - POWER IN
AC input for switching
power supply.
100-240 ±10% VAC,
47-60 Hz.
J2 - RF IN
950-1525 MHz input, -70 to -20 dBm.
see TABLE 2.2.
J1 - IF OUT
140 MHz output, -20 to -30 dBm.
see TABLE 2.2.
J10 - MONITOR AND CONTROL
DB9 female connector.
AC
GN
J1 J2
RF IN IF OUT
J10
AND
MONITOR
CONTROL
5 4 3 2
1
9 8 7 6
J3
10MHz
EXT REF
J3 - 10MHz REF OUT (option -E)
10 MHz external reference input.
BNC female connector.
LNB FUSE
F1
F1 - LNB FUSE (option -L)
1A, Fast Blo, 1/4” fuse. Installing fuse places
+24VDC, 0.4 amps, max on RF IN (J2 center
i )
FIGURE 2.2 2016-05A Rear Panel I/Os
TABLE 2.1 J1 10 2.1 J 10 Pinouts (RS-232C*)
Pin Function
1 Not Used
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4 Not Used
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Closed
8 Not Used
9 Alarm Relay: Normally Open
*Remote Serial Interface
Interface: DB-9 Male
Protocol: RS-232C, 9600 baud rate, no parity, 8 data bits, 1 start bit, 1 stop bit
TABLE 2.2 IFF/RF 2.2 I F/RF Connector Options Options
Option IF RF
STD BNC, 75 Ω Type F, 75 Ω
B BNC, 75 Ω BNC, 75 Ω
C BNC, 75 Ω BNC, 50 Ω
D BNC, 50 Ω BNC, 50 Ω
F Type F, 75 Ω Type F, 75 Ω
J BNC, 50 Ω Type F, 75 Ω
K BNC, 50 Ω BNC, 75 Ω
M BNC, 50 Ω Type N, 50 Ω
N BNC, 75 Ω Type N, 50 Ω
2016-05A Manual, Rev A Page 8 04/17/17