Cross Technologies 1582-03, Инструкция по эксплуатации

Страница: 7 / 11

2.2 Controls and Indicators
The following are the controls and indicators.
POWER
1 2
MODEL 1582
SWITCH
C
ROSS
T
ECHNOLOGIES INC.
ON-
LINE
MANUAL
SELECT
ON-
LINE
RESET MAN REM ALM ALM
AUTO
CH 1 CH 2
SWITCH
FIGURE 2.2 1582-03 CONTROLS AND INDICATORS
TABLE 2.1 FRONT PANEL CONTROLS AND INDICATORS
Item Description
CH1 ON-LINE LED Turns green when Channel 1 is selected
CH2 ON-LINE LED Turns green when Channel 2 is selected
MANUAL LED Turns red when the Manual Select switch manually selects channel 1 or 2.
ALARM CH1 LED Turns red when Channel 1 data times out or on external alarm input
ALARM CH2 LED Turns red when Channel 2 data times out or on external alarm input
REMOTE LED Turns amber when REMOTE control is active
MANUAL SELECT 3-position switch as follows:
LEFT - manually select Channel 1
center - Auto - switch position determined by alarm and Remote closures
RIGHT - manually select Channel 2
If operating in the ICS mode, the last channel manually selected (CH1 or
CH2) will be the initial channel when Manual Switch is returned to Auto
if both channel alarms are clear or both channels are in alarm.
SWITCH RESET Resets switch to CH1 if it is good and switch is in the latch mode,
Also resets Remote selection to normal AUTO operation
POWER 1 LED Turns green when power is applied to AC1 input on the rear panel
POWER 2 LED Turns green when power is applied to AC2 input on the rear panel
1582-03 Manual, Rev. C Page 7 4/13/09