Pg. 17
4. Push down the decompression lever (it will return
automatically when the engine is starting).
5. Turn the starting key clockwise to ‘START’ position.
6. As soon as it starts, release your hand and let the
key automatically return to its initial position. If the
generator doesn’t start after 10 seconds, please wait at
least 15 seconds before attempting again.
RECOIL STARTING (MANUAL START)
!
NOTE: Rapid retraction of the starter cord will pull hand
and arm towards the engine faster than you can let go.
Unintentional start-up could result in an injury.
• Never pull out the recoil start when the diesel engine
is running, as damage may occur.
1. Open the fuel tap to the ‘ON’ position.
2. Set the engine speed lever to ‘RUN’ position.
3. Set ignition key switch to ‘ON’ position.
4. Push down the decompression lever (it will return
automatically when the recoil starter is pulled).
5. Pull out the recoil start handle and prepare to start the
generator.
6. Pull the rope to the point where resistance is felt.
Return the recoil handle to the initial position.
7. Grip the recoil handle firmly and pull quickly and briskly
(Two hands might be needed).
8. Return the recoil gently back to prevent damaging the
starter. Do not allow the handle grip to snap back.
RUNNING THE GENERATOR
!
WARNING: Unapproved adjustment will damage
your engine and/or your electrical devices and void your
warranty.
• The speed has been set at the factory and should not
require readjustment. Consult your local authorised
service agent for advice.
• Warm up the engine for about 3 minutes without load
before using generator.
DURING OPERATION
!
WARNING: Check for unusual sounds or vibrations
during operation.
• Check for misfiring or the engine running rough
• If you notice any above problems, stop the engine and
consult you local service agent.
Cromtech Diesel 6000W Generator Manual April 2020.indd 17
Cromtech Diesel 6000W Generator Manual April 2020.indd 17
21/4/20 7:25 pm
21/4/20 7:25 pm
