Owner's Manual
VE-1P Vertical Edger
Page 22 of 33
SECTION 5 (continued)
Run a piece of glass at least 72 inches long and listen to the cut. If the sound
becomes quieter toward the end of the cut, lower the ingoing conveyor
(
½
turn
of the adjustment screw)
and raise the outgoing conveyor
(
½
turn of the
adjustment screw).
TRAVEL
TRAVEL
To change this condition, the ingoing
To change this condition, the
conveyor adjustment must be raised
outgoing conveyor adjustment
½
turn and the outgoing conveyor
must be lowered
⅛
turn
and the
must be raised
½
turn
.
ingoing conveyor must not be
adjusted.
TRAVEL
TRAVEL
To change this condition, the ingoing
This will move to the left depending
conveyor adjustment must be lowered on the conveyor being adjusted.
⅛
turn
and the outgoing conveyor must To eliminate this condition, adjust
not be adjusted.
both conveyors up
⅛
turn.
Refer back to STEP#5
in SECTION 4 (page 16) to reset depth of cut.
