7
REMOTE ENGINE CONTROL
INFINITY RUN MODE (NOT AVAILABLE ON RS-1300DP MODEL)
This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to
remain running
INDEFINITELY after the programmed run time elapses
. This mode will allow the vehicle to be left
running and unattended
without
the ignition key in the switch preventing the vehicle from being stolen. This mode
can be beneficial to law enforcement or commercial trucks that need to remain running unattended for long periods
of time. See next page for Infinity mode steps.
INFINITY RUN MODE – EXITING THE VEHICLE:
1) With vehicle engine running with the key, press the Remote Start button for at least 1 second, pause a few
seconds, then press and release the remote start button a second time.
2) Parking Lights will start flashing, and doors will unlock.
3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running.
4) The vehicle’s parking lights will flash for the programmed run time of 12, 24, or 36, or 48 minutes and then switch
to solid while motor runs indefinitely or until fuel supply runs out.
SELECTABLE HOURLY COLD-START MODE (1-4 HOURS)
This mode allows the vehicle to be programmed to self-start every 1, 2, 3 or 4 hours and run for the programmed
run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern.
THE
VEHICLE MUST BE OUTDOORS OR IN A WELL VENTILATED AREA!
Once this mode is set, the unit will start
at the programmed hourly interval and run for the programmed run time. To reset this mode, either start the vehicle
with the key or the remote control.
