4
STATUS LED
LED Operation: (install option)
LED will flash when remotely locking your doors.
LED will remain solid in Valet Service mode.
REMOTE ENGINE CONTROL
REMOTE ENGINE STARTING - SUCCESSFUL START:
1) Press the remote start button for at least 1/2 second (*default). (For RS-1300DP models, consult your installer).
2) Parking lights flash once, return solid, and the Ignition/Acc circuits turn on.
3) After a few seconds the Starter Motor engages. The parking lights and Acc circuits will turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Acc turns back on, and the doors lock.
5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can be
turned off with remote transmitter by pressing and releasing the Start button. (For RS-1300DP model, activate
the Green Start input wire)
AFTER
IGN
4
STARTER
THEN
FLASH 1X
SOLID
SOLID
SEC.
THE REMOTE STARTER BUTTON IS PROGRAMMABLE FOR 1 OR 2 PRESSES
REMOTE ENGINE STARTING - UNSUCCESSFUL START
In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then
attempts to restart the engine a 2
nd
and 3
rd
time. For hard starting engines, the unit will allow a starter crank time of
up to13 seconds maximum. This should provide ample cranking time for difficult starts, but is limited to 13 seconds
to help prevent damage to the starter from over cranking.
1) If engine starts on 2
nd
or 3
rd
attempt, see steps 4 & 5 above of "Successful Start".
2) If Third attempt fails to start engine, the system will turn off and doors will remain locked.
NO FURTHER
ATTEMPTS WILL BE MADE AUTOMATICALLY
