7
WIRING Low Current 12 Pin Plug
GRAY: (-) NEGATIVE HOOD PIN SWITCH
Connect the Gray wire to a switch that is at ground when the hood is open. If an existing switch is not available, then we
recommend one to be installed. When this wire is grounded, the remote start is inhibited. The unit will not attempt to start
if hood is open.
PINK: (-) GLOW PLUG or (-) Door switch in Manual Transmission Mode (Programmable)
Connect Pink wire to indicator circuit that shows a (-) Signal while the WAIT TO START LAMP is on. When this wire is
used, the system will wait until light turns off before attempting a remote start. Programmable for 10, 15 or 20 second fixed
time delay.
Default = Glow Plug Delay
PURPLE: (+) BRAKE RESET
Connect the Purple wire to the side of brake pedal switch that shows 12 volts ONLY when pedal is depressed. This is the
wire that turns off the remote start once the driver’s key is in the Ignition and turned to the ON position.
ORANGE / BLACK: (-) OEM DISARM OUTPUT
This wire provides a Ground pulse to disarm the vehicles' Factory anti-theft system prior to a Remote Start. Connect this
wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch or at the
Factory Anti-theft control module. This wire may not be needed if Factory Security only requires a door unlock pulse.
ORANGE: (-) OEM REARM OUTPUT or AUX 2 Output (programmable option 25)
This wire is programmable as OEM Rearm or 2
nd
Aux output. This provides a ground pulse to rearm the vehicles'
FACTORY anti-theft system after a timed-out or aborted remote start. Connect this wire to the vehicles' anti-theft rearm
wire or to the door pin circuit depending on your requirements. This wire may be needed to pulse the door pin circuit on
vehicles with retained accessory power.
RED / WHITE: TACHOMETER INPUT
When installing the system in Tach mode, this wire must be connected to a valid source of AC voltage. This wire allows
the unit to sense the engine running and control the starter motor.
WIRING LED and Valet Switch
PROGRAM OVERRIDE SWITCH: 2 PIN PLUG (REQUIRED FOR PROGRAMMING & LEARNING REMOTES)
This is a multi-function switch used for programming options, transmitters and valet mode.
