27
REMOTE START DIAGNOSTICS
If the system flashes the LED and Parking Lights one to seven times and doesn’t attempt remote. The LED will continue to
flashing the error code until the ignition is turned on, it means the following:
1 Parking Light Flash (1 LED Flash) = Problem with Brake Switch.
2 Parking Light Flashes (2 LED Flashes) = Problem with Hood Switch.
3 Parking Light Flashes (Solid LED) = Valet Service Mode.
5 Parking Light Flashes (5 LED Flashes) = Ignition On before Remote Start or Tach problem.
6 Parking Light Flashes (6 LED Flashes) = Tach Problem (Tach signal without engine running)
7 Parking Light Flashes (7 LED Flashes) = Manual Transmission Error.
Note: In Manual Transmission Mode, the LED will Flash 3 times if the parking park is not set.
HIGH CURRENT 6-PIN HIGH-CURRENT CONNECTOR
(2) RED: 12V POWER INPUT WIRES (30A Fused):
Connect to both of these leads to 12V Constant Power. We recommend the BATTERY POSITIVE TERMINAL.
BROWN: 12V STARTER OUTPUT 30A:
Connect to circuit in the vehicle that has power ONLY while the STARTER MOTOR is CRANKING.
GRAY: 12V MULTIFUNCTION OUTPUT 30A:
This is an optional multi-function output wire the can be configured as a Second IGN, ACC or STARTER output. Use
Option # 26 to select ACC, IGN or STARTER. The
DEFAULT = ACCESSORY
. Connect to circuit in the vehicle that
provides Accessory Power for systems such as HEAT and A/C. Typically, this wire turns ON with the first position of the
key, DROPS OUT WHEN CRANKING, then returns as the engine starts and runs.
PINK: 12V IGNITION OUTPUT 20A:
Connect to circuit in the vehicle that provides true Ignition Power for systems such as Spark and Fuel. Typically, this wire
turns ON with the second position of the key, STAYS ON WHEN CRANKING, and continues ON as the vehicle runs.
PINK / WHITE: 12V MULTIFUNCTION OUTPUT 20A (Option 4):
This is an optional multi-function output wire that can be configured as a Second IGN, ACC or STARTER output. Use
Option # 4 to select ACC, IGN or STARTER. The
DEFAULT = IGNITION
.
