Cricket Remote Control Installation
Appendix A
For Older Cricket Carts that DO NOT have the Freewheel Electronic
Brake release switch follow these steps.
A. Locate the Blue cable going to pin 15 on the sixteen-pin
connector going to the controller.
B. Approximately 3.5 inches from the connector carefully remove
approx. ¼ inch of insulation from the Blue cable.
C. Cut the lug and strip the wire insulation off the end of for the
Blue wire on WH1 to reveal at least ¼ of exposed wire.
D. Splice the Blue cable from WH1 to the Blue cable you removed
the insulation from in Step B.
E. Return to
Step 7
in the main Instruction.
10
Rev 01222019 © 2020 Melbourne Cricket