Crestron
TPS-VIDL-1/TPS-VIDL-2
Video Card for TPS/Lectern Panel
Attach Appropriate Video Cables
S-VIDEO
LUMINANCE
OR COMPOSITE
VIDEO INPUT #1
NTSC/PAL INPUT
S
C
S +
+ -
-
Y
C
Y
COMP
S-VIDEO
CHROMINANCE
OR COMPOSITE
INPUT #2
S-VIDEO
LUMINANCE
OR COMPOSITE
VIDEO INPUT #1
S-VIDEO
CHROMINANCE
OR COMPOSITE
INPUT #2
ON TPS-VIDL-2, USE "COMP/Y" FOR SIGNAL 1
AND "C" FOR SIGNAL 2
NOTE:
When using the TPS-VIDL-2 for receiving two video sources,
the “Comp/Y” connection will be used for Video Source 1 while the
chroma (C) connection will be used for Video Source 2.
NOTE:
Up to four composite video feeds can be physically connected to
a TPS-VIDL-2 (two BNC feeds and two twisted-pair feeds). However,
only two video channels can be selected for viewing from the touchpanel
setup screen. Refer to “Configuring the Touchpanel” on page 12 for more
information.
NOTE:
For additional information on video connections over CAT5,
refer to the latest version of the Crestron CAT5 Wiring Reference Guide
(Doc. 6137) which is available from the Downloads | Product Manuals
section of the Crestron website (www.crestron.com).
12. Reconnect all appropriate cables and install the touchpanel into
the wall or lectern.
NOTE:
Refer to the latest revision of the TPS-4500L, TPS-5000L,
TPS-6000L, or TPS-TPI Operations & Installation Guide (Doc. 5891,
5825, 5783, or 5855, respectively) or, if applicable, BB-5000 or BB-6000
Installation Guide (Doc. 5826 or 5827) for the proper installation
procedure of the touchpanel. The latest version of the Operations Guide
Operations & Installation Guide - DOC. 6070
Video Card for TPS/Lectern Panel: TPS-VIDL-1/TPS-VIDL-2
•
11
