Video Card for TPS/Lectern Panel
Crestron
TPS-VIDL-1/TPS-VIDL-2
Installation and Hookup
The TPS-VIDL-1 and TPS-VIDL-2 video cards are designed for
installation into a dedicated expansion slot on the TPS touchpanel. The
only tools required for installation are a #1 Phillips screwdriver and a
grounding strap (or grounded workstation).
CAUTION:
The TPS-VIDL-1, TPS-VIDL-2, and the touchpanel
contain electro-static discharge (ESD) sensitive devices. Perform the
following procedures while wearing a grounding strap that is properly
grounded and on a grounded workstation to avoid damaging the
TPS-VIDL card and/or the touchpanel.
CAUTION:
To prevent stripping of screw heads, threads, or mounting
holes,
DO NOT
overtighten screws. Tighten only to the specification
listed in the individual step(s).
NOTE:
The diagrams in this procedure show a TPS-6000L touchpanel
but the steps for the TPS-4500L, TPS-5000L and TPS-TPI are identical.
This procedure pertains to a touchpanel or interface that is NOT installed
into a wall or lectern. If already installed, refer to the latest revision of the
TPS-4500L, TPS-5000L, TPS-6000L, or TPS-TPI Operations &
Installation Guide (Doc. 5891, 5825, 5783, or 5855, respectively) or, if
applicable, BB-5000 or BB-6000 Installation Guide (Doc. 5826 or 5827)
for instructions on removing the touchpanel. The latest versions of
operations guides can be obtained from the Downloads | Product Manuals
section of the Crestron website (www.crestron.com).
1. To prevent errors when re-connecting, label each cable attached
to the touchpanel’s rear ports before disconnecting.
2. To prevent scratching of the screen (TPS-TPI excluded), place
the touchpanel facedown onto a padded surface.
3. Refer to the following diagram. Using a #1 Phillips
screwdriver, loosen and remove the
10
screws that secure the
touchpanel rear cover.
6
•
Video Card for TPS/Lectern Panel: TPS-VIDL-1/TPS-VIDL-2
Operations & Installation Guide - DOC. 6070
