Ethernet Card for TPS/Lectern Panel
Crestron
TPS-ENETL
NOTE:
The diagrams in this procedure show a TPS-6000L touchpanel
but the steps for the TPS-5000L and TPS-TPI are identical. This
procedure refers to a touchpanel or interface that is
NOT
installed into a
wall or lectern. If already installed, refer to the latest revision of the TPS-
5000L, TPS-6000L, or TPS-TPI Operations Guide (Doc. 5825, 5783, or
5855, respectively) or, if applicable, BB-5000 or BB-6000 Installation
Guide (Doc. 5826 or 5827). Disconnect power and perform the
installation procedure in reverse to remove the touchpanel or interface.
The latest version of the appropriate guide can be obtained from the
Downloads | Product Manuals section of Crestron’s website
(
1. To prevent scratching of the screen (TPS-TPI excluded), place
the touchpanel face-down onto a padded surface.
2. Refer to the diagram below. Using a #1 Phillips screwdriver,
loosen and remove the
10
screws that secure the touchpanel rear
cover.
Remove Touchpanel Rear Cover Screws
6
•
Ethernet Card for TPS/Lectern Panel: TPS-ENETL
Operations & Installation Guide - DOC. 6013
Содержание TPS-ENETL
Страница 1: ...Crestron TPS ENETL Ethernet Card for TPS Lectern Panel Operations Installation Guide ...
Страница 4: ......