Crestron TPS-6X Series, Руководство по эксплуатации, Страница: 19 / 66

Crestron TPS-6X Series Isys 5.7” Wireless Touch Screens
Operations Guide – DOC. 6875C Isys 5.7” Wireless Touch Screens: TPS-6X Series • 15
SETUP
To enter the “SETUP MODE” menu, touch Setup on the MAIN MENU.
“SETUP MODE” Menu
The “SETUP MODE” menu offers a series of buttons which open additional menus
and screens that are detailed in subsequent paragraphs. After setup parameters have
been selected, touch RETURN to go to the previous menu. When all setup
parameters have been selected, touch
RETURN
repeatedly to go back to the MAIN
MENU.
NOTE: All touch screen settings are automatically saved in non-volatile memory.
The “SETUP MODE” menu also provides data for
COMMUNICATION STATUS
,
BATTERY , DOCKING STATION STATUS and FIRMWARE .
The Crestron Swirl logo in the COMMUNICATION STATUS section
illuminates to indicate the status of the connection to the control system(s). For
details, refer to “COMM” which starts on page 18.
The
COMMUNICATION STATUS section also displays wireless signal strength, RF
ID, gateway connection and ID, Ethernet connection, IP and MAC addresses,
Cresnet connection status and ID and infrared ID.
The
BATTERY
section displays battery charge level and has indicators to show when
the battery is charging and when AC power is connected.
NOTE: When battery power is low, the TPS-6X shows a warning message. The key
backlight is turned off and the display backlight dims to minimum until the battery is
recharged or the unit is docked. If battery power drops to 4%, saving of panel
settings is not guaranteed.
NOTE:
The battery charge level percentage indicator gets more accurate after a few
charge/discharge cycles. Periodic (monthly) full discharge is recommended to
maintain accuracy of the percentage measurement.
The DOCKING STATION STATUS section has an indicator to show docked status.
The RELEASE button is used to release the touch screen from its (optional)
TPS-6X-DSW docking station.