Crestron QuickSwitch HD-MD8X1, Руководство по эксплуатации и установке

Страница: 19 / 32

Crestron HD-MD8X1/HD-MD8X2 QuickSwitch HD HDMI Switcher
Operations & Installation Guide – DOC. 6714B QuickSwitch HD HDMI Switcher: HD-MD8X1/HD-MD8X2

15
Hardware Hookup
Connect the Device Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to “Network Wiring” on page 12 before attaching the 4-position
terminal block connectors. Apply power after all connections have been made.
Hardware Connections for the HD-MD8X1/2 (HD-MD8X2 Shown)
INPUT:
From HDMI
Sources
OUTPUT 1-2:
To HDMI
Receiver
or Display
LAN:
10BASE-T/
100BASE-TX
Ethernet to LAN
COMPUTER:
To USB Port
on PC
NET:
Power from Cresnet
Power Supply and
to Cresnet Devices
Ground
NOTE: Ensure that the unit is properly grounded by connecting the chassis ground
lug to an earth ground (building steel).
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
Label the Buttons Use Crestron Engraver software to print custom labels for the HD-MD8X1/2’s front
panel buttons and LEDs. Crestron recommends printing on 100-pound paper. Paper
weighing less than 100 pounds tends to crumple while sliding in, while paper
weighing more than 100 pounds may not fit.
HDCP Signal Path
Sources using HDCP limit the number of display devices it can transmit to while
simultaneously limiting the depth of devices in the signal path. Too many devices or
greater than the allowed depth in a signal path (from source to display) may create
problems with the display of audio and video content. The HDCP specification states
that the maximum depth of devices between source and display is six. Examples are
provided in the following diagram.