Crestron QuickSwitch HD-MD8X1, Руководство по эксплуатации и установке

Страница: 18 / 32

QuickSwitch HD HDMI Switcher Crestron HD-MD8X1/HD-MD8X2
14

QuickSwitch HD HDMI Switcher: HD-MD8X1/HD-MD8X2 Operations & Installation Guide – DOC. 6714B
To install the ears:
CAUTION: To prevent equipment damage, use only the rack ears Crestron
provides for this device.
1. There are screws that secure each side of the HD-MD8X1/2 top cover.
Using a #2 Phillips screwdriver, remove the three screws closest to the front
panel from one side of the unit. Refer to the diagram following step 3 for a
detailed view.
2. Position a rack ear so that its mounting holes align with the holes vacated
by the screws in step 1.
3. Secure the ear to the unit with three screws from step 1 as shown in the
following diagram.
Ear Attachment for Rack Mounting
Use Cover Screws
4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the
opposite side.
Stacking Four “feet” are provided with the HD-MD8X1/2 so that if the unit is not rack
mounted, the rubber feet can provide stability when the unit is placed on a flat
surface or stacked. These feet should be attached near the corners prior to the hookup
procedure.
NOTE: No more than two HD-MD8X1/2 units should be stacked.