Crestron QuickMedia QM-RX, Руководство по эксплуатации

Страница: 14 / 48

QuickMedia™ Receiver Crestron QM-RX
IR
A 2-position terminal block connector is a mini-implementation of a single
PRO2 IR port. The output is labeled S (signal) and G (ground). Infrared output
is rated up to 1.2 MHz, at data rates up to 115k baud. Serial protocols include
one-way RS-232.
INPUT
This 2-pin terminal block connector provides one software programmable
digital input. The input is a Schmidt trigger type (nominal 2.5 V threshold)
with 24 V input tolerance.
The digital input is rated 0 – 24 VDC, 20 K ohms input impedance.
SETUP LED and Pushbutton
The QM-RX is TouchSettable ID (TSID) ready. The SETUP pushbutton and its
associated LED are located on the front of the unit and are used for setup of the
QM-RX network ID during the initial configuration of a Cresnet system or when
the device is being added or replaced.
Industry Compliance
As of the date of manufacture, the QM-RX has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Setup
Network Wiring
CAUTION: In order to ensure optimum performance over the full range of
your installation topology, Crestron Certified Wire, and only Crestron Certified
Wire, should be used. Failure to do so, may incur additional charges if support is
required to identify performance deficiencies as a result of using improper wire.
CAUTION: Provide sufficient power to the system. Insufficient power can lead
to unpredictable results or damage to the equipment. Please use the Crestron
Power Calculator to help calculate how much power is needed for the system
(http://www.crestron.com/calculators).
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure
to do so could cause equipment damage or void the Crestron warranty.
● QuickMedia Receiver: QM-RX Operations Guide – DOC. 6333
10