Crestron QM-RMCRX-BA, Руководство по эксплуатации

Страница: 14 / 76

QuickMedia™ Receiver/Processor Crestron QM-RMCRX-BA
Front Panel Ports
The QM-RMCRX-BA front panel ports are illustrated and described as follows.
Q M
8
1
QM Input
The eight-pin RJ-45 QuickMedia transport port accepts CAT5E audio, video,
microphone, and control signals. The QM input port conforms to the 568B
wiring standard. The associated QM LINK LED indicates a QM connection.
Refer to page 16 for network wiring information and refer to page 6 for
pinouts.
24 Y Z G
NET
24 Y Z G
NET
These connectors are used for expansion to Cresnet peripherals. Power to the
unit can be supplied through this connector. The associated NET LED
indicates network activity.
24 VDC
2.0 A
24VDC, 2.0A (Power Supply Input)
This male connector can be used to supply 24 VDC power to the
QM-RMCRX-BA from an external power pack (included).
CAUTION: Use only Crestron power supplies for Crestron equipment.
Failure to do so could cause equipment damage or void the Crestron warranty.
LAN
8 1
Yellow
Green
LAN
An 8-position RJ-45 port (labeled LAN ) is used for connection to the
Ethernet, providing local area network or Web access (cable is not supplied).
The port also contains two light-emitting diodes (LEDs). The green LED on
the right side of the port is a link status LED and illuminates when the card is
connected to a working network. The yellow LED on the left side flashes to
indicate Ethernet activity. Refer to page 22 for Ethernet cabling details.
SPEAKER
L
+ -
R
+ -
SPEAKER
The speaker output consists of two 2-pin terminal block connectors, 5 mm
spacing. These connectors have left and right amplified stereo audio output,
10 watts per channel into 4 or 8 ohms.
10
•
QuickMedia™ Receiver/Processor: QM-RMCRX-BA Operations Guide - DOC. 6332