Reset the Device
A DHCP reset, hardware reset, factory restore, or power cycling all
outlets may be performed when troubleshooting.
DHCP Reset
1. Ensure the device is powered on.
2. Press and hold the HW-R button for 1 second and release it for less
than 2 seconds.
3. Repeat step 2 five times.
The device will reboot, and the network settings will be reset to
default: default Hostname, DHCP enabled, and no static IP.
Hardware Reset
This process is equivalent to disconnecting the device from the power
source and then reconnecting it to clear a fault.
1. Ensure the device is powered on.
2. Press and hold the HW-R button for at least 3 seconds and release.
The device will reboot.
Factory Restore
1. Ensure the device is powered on.
2. Press and hold the HW-R button for 15 seconds until all status LEDs
blink twice to indicate the restore command has been executed
successfully.
The PWR LED blinks amber during the factory restore process. The
device will then reboot, and all factory settings will be restored.
CAUTION:
Performing a factory restore will clear all settings from
the device configuration.
Power Cycle All Outlets
1. Ensure the device is powered on.
2. Tap the HW-R button for less than 1 second.
The power cycling initiates for all outlets.
14
PC-350V-12 and PC-350V-18
Quick Start
Vertical Networked Power Controller & Conditioner with Surge Protection and Metering
