Crestron MP-FS-RX1, Руководство по эксплуатации и установке

Страница: 12 / 20

Single/Dual-Channel Wireless Mic Receiver Crestron MP-FS-RX1/RX2
8 • Single/Dual-Channel Wireless Mic Receiver: MP-FS-RX1/RX2 Operations & Installation Guide – DOC. 7164B
Setup
Installation
The MP-FS-RX1/RX2 can be placed on any convenient flat surface in the room,
such as a desk, shelf, table, or ceiling-mounted third-party equipment platform.
• Install all accessory hardware, including power pack, MP-FSIR Beacon
Sensor(s), MP-FS-PAS Audio Sensor, FS6 or FSDI8 speakers, following
their supplied instructions.
• For the MP-FS-RX1, attach the supplied single antenna; for the
MP-FS-RX2, attach the cables from the two supplied antennas (the antennas
should be spaced at least 6 feet (~ 2 meters) apart.
• Orientation of antennas for desk, shelf, or table mounting installations
should be straight up. For ceiling mounted installations (including the
MP-FS-RX1 on a third-party ceiling-mounted equipment platform), antenna
orientation should be straight down. For wall-mounted installations, the
antennas should be at a 45° angle, either up or down, from the wall.
• Install all other required interconnecting cables.
Hardware Hookup
Make the necessary connections as called out in the illustration that follows this
paragraph. Apply power after all connections have been made.
When making connections to the MP-FS-RX1/RX2, use Crestron power supplies for
Crestron equipment.
Hardware Connections for the MP-FS-RX1/RX2
NOTE:
Ensure the unit is properly grounded by connecting the chassis ground lug
to an earth ground (building steel).