Crestron MiniTouch MT-1000C, Руководство по программированию

Страница: 27 / 36

Crestron MT-1000C 3.8 Inch RF Remote
Project Upload and Firmware Upgrade
Before loading a compiled VT Pro-e project or upgrading the device firmware,
the USB cable supplied with the MT-1000C must be connected to the USB
interface port on the rear of the MT-1000C and the USB port of the PC as shown
in the following diagram.
NOTE: You cannot operate the MT-1000C while a file is loading.
NOTE: All of the communication parameters are automatically set when
uploading to the MT-1000C.
NOTE: An error message will appear on the PC if you have installed the USB
connector up side down.
Typical Connection Diagram when Uploading and Upgrading
NOTE: The Crestron Toolbox (replacement for Crestron Viewport) is a broad-
based software package that accomplishes multiple system tasks, primarily using
an RS-232 or TCP/IP connection between a PC and one or more Crestron
control systems. You can use the Crestron Toolbox to:
● Observe system processes
● Upload operating systems and firmware
● Upload programs and touchpanel projects
● Set or change device Network IDs
● Change serial numbers
● Run scripts to automate tasks
● Perform system diagnostics, and much more
The Crestron Toolbox allows you to perform these functions using simple
graphical views and click and drag methods.
Programming Guide – DOC. 6330A 3.8 Inch RF Remote: MT-1000C
•
23