Crestron Isys TPS-4L, Руководство по эксплуатации и установке, Страница: 12 / 36

3.6-Inch Wall Mount Touchpanel Crestron Isys
®
TPS-4L
Configuring the Touchpanel
MAIN MENU
This menu can also be obtained
via digital reserved join number,
17242.
NOTE: The only connection required to configure the touchpanel is power. Refer
to “Hardware Hookup” on page 15 for details.
NOTE: The touch screen responds to both finger and stylus commands. Since the
screen is small, Crestron recommends that a stylus (not supplied) be used to ensure
the accuracy of commands. Use a stylus that will not damage the surface of the
screen.
Prior to normal operation, it is advisable to configure the unit using a series of setup
screens. The MAIN MENU for configuring the touchpanel appears when a finger
(or stylus) is held (approximately five seconds) to the touchscreen when power is
applied or when the reset button is pressed.
Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four
buttons:
Touch Screen Calibration , Exit and Run Program , Setup , and
Diagnostics .
Selecting Exit and Run Program verifies that all of the setup information has been
saved to EEPROM and displays the main page that has been programmed into the
touchpanel. The remaining buttons on the MAIN MENU open other menus, which
are discussed in subsequent paragraphs.
Calibration Menu
CALIBRATION MENU
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the
Touch Screen Calibration button
to display the CALIBRATION MENU, as shown to the left. The CALIBRATION
MENU offers the choice to initiate calibration with the
Perform Calibration
button or return to the previous screen with the Return button. Choose an option by
touching the appropriate button.
If you need to calibrate the touchpanel, the screen displays the message "Touch
Upper Left" centered on the panel with a cross hair in the upper left corner. Touch
the cross hair to initiate calibration. Another message, "Touch Upper Right",
appears with a cross hair in the correct corner. Touch the cross hair. A final
message, “Touch Lower Right”, appears with a cross hair in the correct corner.
Touch the crosshair to finish the calibration and return to the MAIN MENU.
NOTE: When touching each crosshair during calibration, be as accurate as possible.
Use a stylus or the tip of a capped pen or the eraser end of a pencil. To cancel
calibration and return to the CALIBRATION MENU without saving calibration data,
create a calibration error by touching the screen in an area that is opposite from the
instructed area.
8
•
3.6-Inch Wall Mount Touchpanel: TPS-4L Operations & Installation Guide – DOC. 6449A