Crestron Isys
®
TPS-4000
10.4 Inch Tilt Touchpanel
AUDIO Pinouts
TYPE PIN
DESIGNATION
DESCRIPTION
1
L+
Left Input (Positive)
2
L-
Left Input (Negative)
3 GND/Shield
Audio
Input Ground/Shield
4
R+
Right Input (Positive)
5
R-
Right Input (Negative)
6
GND/Shield
Mic Output Ground/Shield
7
M+
Mic Output (Positive)
1
8
1
8
Front
Top
8
M-
Mic Output (Negative)
To determine the location of pin 1, hold the supplied cable so that the end of the
8-pin RJ45 connector is facing away from you, with the clip side down and the
copper side up. The copper contact on the far left is pin 1.
NOTE:
When connecting the touchpanel to the interface module, do not confuse the
8-pin audio cable with the 10-pin net/video cable.
RS-232
This 6-pin RJ-11 connector mates with a 9-pin serial port of a PC. The connecting
cable is not supplied. Use this port to establish a direct connection between the
touchpanel and a PC without a control system or network connection. Once the
direct connection is established, touchpanel files and firmware updates can be
uploaded to the touchpanel. Additionally, the touchpanel’s diagnostic tools can be
accessed over the direct connection. In the event that modular cables or an RJ-11 to
DB9F adapter is not available, the following table and diagram provide information
so that the cable can be fabricated on site. Refer to “RS-232 Menu” on page 13 for
proper RS-232 port configuration settings.
RS-232 Pinouts
PIN #
DESCRIPTION
1 CTS
2
GND
3 RXD
4
TXD
5 RTS
6
N/C (Not connected)
1
6
1
6
Front
Top
PC to TPS-4000 Cable Specifications (Crestron Cable Number STCP-502PC)
Operations Guide - DOC. 6268
10.4 Inch Tilt Touchpanel: Crestron Isys
®
TPS-4000
•
15
Содержание Isys TPS-4000
Страница 1: ...Crestron Isys TPS 4000 10 4 Inch Tilt Touchpanel Operations Guide...
Страница 4: ......
