DO
GUIDE
DO
Install the Device
The Crestron
®
DM-RMC-200-C mounts into a 2-gang electrical box using the included support
bracket. The support bracket provides a holder for the included power pack.
Mounting the Device into an Electrical Box
To mount the device into an electrical box, do the following:
1. Using the four included 6-32 x 3/4" combo truss head screws, attach the support bracket
to the electrical box.
2. Ground the DM-RMC-200-C and connect the proper cables to the bottom of the unit.
3. Using the four included 6-32 x 1" Phillips pan head screws, attach the DM-RMC-200-C to
the support bracket.
Inserting the Power Pack into the Power Pack Holder
To insert the power pack into the power pack holder, do the following:
1. Slide the power pack into the power pack holder.
2. Using the included 6-32 x 1/2” Phillips
pan head screw, thread the screw
through either of the two provided screw
holes to hold the power pack in place.
3. Bundle the excess cable of the power
pack into a loop, and then fasten the
bundled cable to the power pack holder
by doing the following:
a. Insert one of the included tie wraps
through one of the tie wrap holes in
the power pack holder.
b. Wrap the tie wrap around the
bundled cable.
c. Repeat steps 3a and 3b if
necessary using the other included
tie wrap and the remaining tie wrap
hole in the power pack holder.
DM-RMC-200-C
DigitalMedia 8G+
®
Receiver and Room Controller 200
DO
Check the Box
QTY PRODUCT
COLOR
PART NUM.
1
Bracket, Support
2047590
2
Connector, 2-Pin
2003574
4
Connector, 2-Pin
2003582
2
Connector, 4-Pin
2003576
1
Connector, 5-Pin
2003577
1
Power Cord, 5' 10" (1.78 m)
2042043
1
Power Pack, 24 Vdc 2.5 A, 100-240 Vac
2045873
1
Screw, 6-32 x 1/2", Pan Head, Phillips
Black
2007238
4
Screw, 6-32 x 1", Pan Head, Phillips
Black
2007250
4
Screw, 6-32 x 3/4", Truss Head, Combo
2009211
2
Tie Wrap, Cable Tie, 15-1/2" x 1"
Black
2013608
Tie wrap
hole
Tie wrap
hole
Screw
hole*
Screw
hole*
*Use either screw hole for the included
6-32 x 1/2" Phillips pan head screw.
DM IN:
From DM
®
switcher, transmitter, or
other DM device or from HDBaseT
®
device
DIG IN:
Software programmable
digital output
Ground
RELAY:
To relay
controllable
devices
AUDIO OUT:
Amplified stereo audio output
