Swap the Roller Shade Idler and Motor
If the idler and motor brackets have been swapped, remove the motor
and idler from the tube and remount in the opposite ends, allowing the
fabric to roll off of the tube in its intended manner
Swap the idler and motor ends of the roller shade.
1. Remove the motor by pulling on the motor head.
2. Use the idler removal tool to loosen the idler by rotating the idler
counterclockwise. Pull the idler out of the tube.
3. Insert the motor into the tube end opposite from where it was
removed.
4. Insert the idler into the tube end opposite from where it was removed.
5. Use the idler removal tool to tighten the idler; rotate the idler clockwise
two turns, and then tighten until snug. Pull on the idler to confirm it is
properly secured.
Mount the Fascia
Once the assembly is installed and programmed, the fascia can be
mounted.
Align the fascia with the mounting brackets and then press the fascia into
place. The fascia assembles into place by snapping onto the tabs on the
bracket. Place the top of the fascia on the top of the bracket first, and
then press the bottom of the fascia into place on the bottom of the
bracket.
To remove the fascia, pull the bottom of the fascia down to clear the
bottom tab on the bracket. Then, pull the fascia away from the window
and upward to release the top of the fascia.
Mount the Fascia (CSA-ARCH5-BRKT)
18
CSA-ARCH5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
