Level the Shade Fabric
WARNING:
Shade fabric should be leveled as each band is mounted. If all
the shades are mounted, and the collar of any band is unlocked, all of the
bands after the unlocked band are released and the fabric will rapidly
drop to the floor. This can cause damage to the fabric and harm to the
installer.
NOTES:
l
Before leveling the fabric, run the shades through three full open and
close cycles to allow for the fabric to settle on the tube.
l
Leveling must be performed with the bottom of the shade fabric at
eye level.
1. Fully lower the shades. The shade fabric on the drive band should be at
or close to the sill level when the shades are being leveled.
2. If the drive band and next intermediate bands are not level, rotate the
intermediate band to raise the fabric. The fabric should be 2 in.
(51 mm) above the bottom edge of the drive band.
3. Use the spanner wrench on the drive band to rotate the collar in the
direction of raising the shade. This mechanically releases the shades
from each other and allows the adjacent shade to be lowered
independently of the drive band.
NOTE:
The adjacent roller tube must be held while the collar is being
rotated. When the collar reaches the end of its travel, the fabric on
the adjacent shade will unravel.
4. Once the bottoms of the fabrics are aligned, rotate the collar on the
drive band in the direction of lowering the shade until it reaches a hard
stop to prevent the adjacent band from unraveling further.
5. Run the shades through three full close and open cycles to allow the
fabric to settle on the tube, and check that they are level. If the shades
are not level, repeat steps 1—4.
6. Repeat this procedure for all adjacent bands.
14
CSA-ARCH5 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
