CRESTRON
2
••
Wired 8 Button Control Panel: CNWM-8
Operations Guide - DOC. 8130
Leading Specifications
The table below provides a summary of leading specifications for the CNWM-8.
Dimensions and weights are approximations rounded to the nearest hundredth unit.
Leading Specifications of the CNWM-8
SPECIFICATION
DETAILS
Power Requirements
24 VDC
Power Factor
5 Watts
SIMPL Windows
TM
Version 1.18 or later
CNX Operating System
Version 1.0.0 or later
Dimensions & Weight
Height: 4.62 in (11.74 cm)
Width: 2.86 in (7.26 cm)
Depth: 1.97 in (5.01 cm)
Weight: 0.61 lb (0.27 kg)
NOTE:
Depth measurement is taken from grommet to buttons.
Setup
Identity Code
NOTE:
It is safe to adjust the identity code of the CNWM-8 while the unit is
connected to the network. However, if the code is changed while the unit is
powered, the new code will not be recognized until power is removed and reapplied.
Each device on the network requires a unique identity code (NET ID). Each code
consists of a two-digit hexadecimal number from 03 to FE. The NET ID of each
unit must match the network address of the CNWM-8 in SIMPL Windows in order
for the device to be addressed properly. The NET ID of each CNWM-8 has been
factory set to 11, but may be changed. To alter the unit’s NET ID, make sure power
to the unit is disconnected and complete the following steps.
1.
Locate the two miniature rotary switches labeled HI and LO on the
rear face of the unit, shown below. The rotary switch marked HI
represents the most-significant digit or number of the ID CODE and
the one marked LO represents the least-significant digit or number of
the ID CODE. Each 16-position rotary hexadecimal switch can be set
to a value ranging between 0 and F.