Crestron Cameo INET-CBDEX Series, Руководство по эксплуатации и установке, Страница: 26 / 40

Cameo Keypads with infiNET EX Crestron INET-CBDEX Series
20 • Cameo Keypads with infiNET EX Operations & Installation Guide - DOC. 6992D
Joining an infiNET EX Network
Before an INET-CBDEX can be used in a lighting system, it must first
join an infiNET EX network by being acquired by an infiNET EX
gateway.
NOTE: An INET-CBDEX can be acquired by only one gateway.
To acquire an INET-CBDEX, perform the following:
1.
Put the infiNET EX gateway into
Acquire
mode from the unit itself or
from Crestron Toolbox, as described in its manual, available at
www.crestron.com/manuals .
NOTE : In an environment where multiple gateways are installed,
only one gateway should be in the Acquire mode at a time.
2. Place the INET-CBDEX into
Acquire
mode by doing the following:
a. Tap the top button three times then press and hold it down (tap-tap-
tap-press+hold) until the top LED on the device flashes once (this
can take up to 10 seconds).
b. Release the button to start the acquire process. The top LED blinks
slowly to show that the device is actively scanning the infiNET EX
network.
• The device is acquired when the LED stops blinking.
• If the acquire process fails, the LED flashes rapidly until a
button is pressed.
3. Take the infiNET EX gateway out of Acquire mode from the unit
itself or from Crestron Toolbox.
Leaving an infiNET EX Network
To leave a network, simply place the INET-CBDEX into Acquire mode
(step 2 above) when there is no gateway in Acquire mode.