Multigang Installations
In multigang installations, several devices are grouped horizontally in one
electrical box. For a smooth appearance, one-piece multigang faceplates
(not supplied) can be installed.
NOTE:
When installing into a multigang box, do not fully tighten devices
to the box until the faceplate has been aligned.
The load capacity for each device in the electrical box must be derated.
Refer to the following diagrams for derating information. The VA ratings
are for input power to the transformer. If you do not know the input
power requirement of the transformer, use the bulb’s wattage rating to
determine proper rating.
Derating Information for CLW-DIMUEX-P Dimmers
Changing the Button Assemblies
The button assembly can be removed and replaced to accommodate
custom button configurations and engravings.
1. Remove the button assembly by squeezing the sides of the bezel near
the bezel snaps. When the button assembly is removed, power to the
load, the buttons, and the LEDs is removed automatically.
NOTE:
When the button assembly is removed, power is still supplied
to the HOT terminal.
3
CLW-DIMUEX-P
Quick Start
Cameo® In-Wall Universal Phase Dimmer, 120 VAC