Crestron C2N-NPA8, Руководство по эксплуатации

Страница: 28 / 40

Network Poll Accelerator Crestron C2N-NPA8
“Port Settings” Window
NOTE: The parameters shown in the illustration above are the port settings for a 2-
Series control system. Consult the Operations Guide for the control system being
used for exact parameter selection.
If using a TCP/IP connection, select TCP/IP (Crestron Terminal
Protocol) and enter the IP information for the control system. Click the
OK button to save the settings and close the window.
4. To verify communication, select Diagnostics | Establish
Communications (Find Rack) . This should display a window that
gives the COM port and baud rate. If communication cannot be
established, refer to the “Troubleshooting Communications” section in
the respective Operations Guide for the control system.
Uploading a SIMPL Windows Program
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system.
Once communication with the control system has been established, a SIMPL
Windows program containing a C2N-NPA8 can be uploaded to the control system
using SIMPL Windows or the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window, navigate to the SIMPL
Window file (.smw), and click Open .
3. Select Project | Transfer Program .
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on
page 22 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P ) from the Viewport menu.
24
•
Network Poll Accelerator: C2N-NPA8 Operations Guide – DOC. 6087A